24 microphones

1 Channel In (does not use any input channels in CONVERGE Pro 2)

Number of Beams:
- 5 in Ceiling mode
- 6 in Table mode
- 6 in Table mode

Polar Pattern: Custom

Frequency Response: 150Hz – 16kHz, +/- 3dB

Dynamic Range: 150Hz – 16kHz, >70dB

Sensor Type: 2 Capacitive Touch Button for Mute

LED (2x: one on each end of a unit):
- Power On
- Power On & Unmuted: Blue

Muted: Red

Power Off: No light

Beam enable/disable

Mounting mode selection:
- Auto
- Ceiling
- Wall
- Table

Acoustic Echo Cancellation (AEC) on/off

Noise Cancellation (NC) on/off

Filters:
- All Pass
- Low Pass
- High Pass
- Notch
- PEQ

Automatic Level Control (ALC) on/off

Gain adjust

Mute on/off

Auto gate/Manual gate

For future use

P-Link In & Out: Proprietary Peripheral Bus

Ports Type: RJ-45

Cable: Solid core 24AWG, factory terminated Cat 5e or Cat 6

Distance: Up to 200 feet

Sub-standard: Mode B

Daisy-Chain:
- Up to 3 Beamforming Microphone Array 2 units with each supported CONVERGE Pro 2 unit in the same chain
- Up to 3 Beamforming Microphone Array 2 units and up to 3 DIALOG 20 Wireless Receiver units with each supported CONVERGE Pro 2 unit in the same chain
- Up to 6 Beamforming Microphone Array 2 units in the same chain with 2 supported CONVERGE Pro 2 units connected through C-Link (future software/ firmware upgrade)

Long Distance P-Link:
- Increases P-Link distance from 200 Ft to 650 Ft 650 Ft (200M) maximum cable distance between any two units
- Cat6, 550 MHz, 23 AWG, solid conductor cable Do not use Copper Clad Aluminum (CCA) cable Available only for BFM2 peripheral units
- 48V PoE Midspan Mode B power injector for 1 BFM2 unit
- 56V PoE Midspan Mode B power injector for 3 BFM2 units